2. OPERATION
2-24
2.14.2 How to set the positioning conditions
1. Open the [GNSS] menu.
2. Select [POSN. CONDITION], then press the ENT key.
3. Referring to the table below, set the conditions for position fixing, then press the
ENT key.
4. Close the [MENU].
Menu item Options Remarks
QZSS • [OFF]
• [ON] (default)
Enable/disable the use of the QZSS system.
ELEVATION MASK For technical personnel only. Not changeable.
IGNORED GNSS [000] to [999] The system uses the on-board almanac to ig-
nore satellites which are known to provide in-
correct data. However, some of these
satellites may not be registered in the alma-
nac. You can add satellites to be ignored us-
ing this function.
1) Select the satellite network to which the
satellite you want to ignore is registered.
The [IGNORED SATELLITE] window ap-
pears.
2) Enter the satellite number to be ignored.
You can enter up to 3 satellites per net-
work.
Press S to increase the value, T to de-
crease the value and press X or W to
move the input cursor.
3) Select [ENTER], then press the ENT key.
To Next Page
Loading...
