1. INSTALLATION
1-28
1.7 How to Access and Use the [SERVICE] Menu
Menu items which require service level access are shown in gray. A password, ob-
tained from FURUNO, is required to access the [SERVICE] menu. Several initial set-
tings must be done from this menu to complete the setup of your SC-70 or SC-130.
To adjust or change any of these settings, consult your local dealer.
1.8 I/O Menu Settings
To set which data to output to external equipment from the SC-70/ SC-130, see
section 2.15.
1.9 Initial Settings for the Remote Display
After wiring is complete for all units in the configuration, setup the [ROTI Display] as
follows. The RD-50 requires menu setup.
For detailed operational guidance for either Remote Display unit, see the appropriate
Operator’s Manual (RD-50: OME-44530-x, RD:20: OME-44540-x: “x” denotes ver-
sion).
How to setup the RD-50 for ROTI display.
1. Open the [SERVICE] menu for the RD-50.
2. Select [Device Mode], then press the ENT key.
Note: Do not change the settings for any other items in the [SYSTEM] menu for
the RD-50.
3. Select [ROTI], then press the ENT key.
4. Press the PWR key to close the menu and turn off the power. When the power is
next turned on, your RD-50 shows the [ROTI Display] from the SC-70/SC-130.
How to setup the RD-20 for ROTI display
Press the DISP key on the RD-20 to show the ROTI display.
XXXX: Serial number
XX: Program version number
UNIT Name : RD-50
Serial No : 6408-XXXX
PWB No : 26P0006-XX
Remote Dimmer : Main
Depth Select : Auto
Depth Position : Single
L/L Digit : 4digit
Without Checksum : Disable
I/O Port
Port1 : 4800
SIO Monitor
Sensor Out : ON
Device Mode : Normal
LCD RESET
SIM : OFF
Service RESET
[
▲
]
/
[
▼
]
:
Select
[
ENT
]
: Enter
To Next Page
Loading...
