Furuno SC-130 - How to Access the Alert Log

2. OPERATION
2-18
2.11.4 How to access the alert log
The alert log shows the latest 50 alerts. When the log becomes full, the oldest entry is
erased to make room for current alerts. To access the alert log, do the following:
1. Open the [MENU].
2. Select [ALERT], then press the ENT key.
3. Select [ALERT LOG], then press the ENT key.
4. Press S or T to scroll up or down through the alert log.
5. Press the DISP key to close the [ALERT LOG].
Note: The [ALERT LOG] can also be accessed from the [LIST] display. Press the
LIST key to cycle through the lists.
How to interpret the alert log
No.
Indication
name
Description
1DATUM, OS
coordinates,
Calculation sta-
tus, [HDG],
[ROT]
See section 2.11.3.
2 Alert code and
message
Alert code appears in six digit format.
Note: A full list of alert codes, meaning and measure is includ-
ed at "ALERT LIST" on page AP-4.
3 Alert number Number assigned to the selected alert by the alert log. Up to
50 alerts are stored.
Note: This is not an alert code.
4 [ACK] Time and date the alert was acknowledged.
5 Alert priority The priority level assigned to the selected alert. Displayed as
"WARNING" or "CAUTION".
6 Alert time /
coordinates
Time of alert, coordinates at time of alert.
7 [RECT] Time and date alert was rectified.
R
ECKONING440301 DEAD
R
N
O
RMA
L
C
AUTION