FUTABA T16IZ User Manual

165
→ GO to TABLE OF CONTENTS
This function is used to adjust the pitch and
the throttle rise characteristic at acceleration/
deceleration operation. An acceleration function
which temporarily increases the pitch and throttle
operations at throttle stick acceleration/deceleration
operation can be set.
Exampleofaccelerationfunctionuse
●When used at pitch, the acceleration
function is effective when you want to
quicken the response of the fuselage at 3D
ight ip, etc.
When used, high pitch temporarily exceeds
maximum pitch, but immediately returns to
maximum pitch.
Setting method
● Acceleration can be set at both setting
at acceleration (high) and setting at
deceleration (low).
(The operation point is displayed on a
graph.)
● Acceleration rate setting (Rate)
● The return time after operation (Damping)
can be set.
Acceleration
● Select [Acceleration] at the model
menu and call the setup screen shown
below.
Operation up to this
range will initiate
acceleration.
Act position
The rate the angle
increases.
To next page
1/2 : Pitch
2/2 : Throttle
The return time after operation (Damping)
can be set.
（First return）1 ～ 100（Slow return）
（Acceleration doesn't function as 0.）
When using this
function, Tap [INH].
(ON is displayed.)
Condition group/
single mode selection
(Gr. /Sngl)
Current position
● The operation point at acceleration
and deceleration can be set. When an
operation point is exceeded, acceleration is
performed.
Note: When using the acceleration function,
since the pitch stroke is large, make your
settings so there is no binding of your linkage.
●Return to Model menu

FUTABA T16IZ Specifications

General

Channels	16
Frequency	2.4GHz
Telemetry	Yes
Voice Alerts	Yes
SD Card Slot	Yes
USB Port	Yes
Trainer Port	Yes
Modulation	T-FHSS, S-FHSS
Display	4.3-inch color touchscreen
Battery	7.4V 2000mAh
Model Memory	30 models