12
RANGE CHECK THE RADIO
adequate operational range.
check. During this mode, the RF power is reduced in order to test the operational range of the T6J.
the full range mode. In most instances, 90 seconds is more than an adequate amount of time to allow for a
complete range check.
To activate the Power Down Mode and Perform A Range Check:
switch on. When this mode is active the blue LED on the front of the transmitter will begin blinking and
Down Mode”.
Audibly, the transmitter will beep one time every three seconds until it reaches the 90 second time limit. At
which time the transmitter will beep two times and then return to the full power mode.
simultaneously operating the controls. Have an assistant stand by the model and
be able to walk approximately 30-50 paces from the model without losing control.
3) If everything operates correctly, return to the model. Set the transmitter in a safe yet accessible location
so it will be within reach after starting the engine. Be certain the throttle stick is all the way down, and then
start the engine. Perform another range check with your assistant holding the model and the engine running
at various speeds.
servo connections or binding pushrods. Also be certain that the battery has been fully charged.
To Next Page
Loading...
Need help?
General
