68
The countdown and count up timers may be assigned to switches A, B or D (either up or down position),
always ON or activated by the throttle stick movement. The countdown and count up timers may be
hours and 59 minutes.
It is also important to note that the timers are stored independently with each model, meaning that when
switching between models, the timer associated with the model is brought up automatically.
The Model (MDL) timer is the default setting for the timer function. It is automatically activated and there
again.
To reset the Model Timer:
As noted above, the model timer is not programmable. If a countdown or count up timer has not been
activated in the T6J, the model timer will begin counting up automatically when the transmitter is turned on.
1) To view the time from the default screen, press the SELECT button. The
transmitter voltage will be replaced by the MDL timer on the LCD.
2) To reset the model timer, press and hold the DATA INPUT lever either upward or
with an audible double beep.
To Set the Countdown or Count Up Timer:
1) Turn the transmitter on.
2) Press and hold the MODE button to access the programming mode.
3) Press either the MODE key OR the END key to scroll through the function menus.
Continue pressing the MODE or END key until the timer (TIMR) menu appears on
screen.
lever either upward or downward to select between the UP (count up) or DWN
(count-down) timers.
move to the timer setting screen.
To Next Page
Loading...
Need help?
General
