______________________________________________________________________________
____________________________________________________________________________
Page 4-110 LMM for the Kodiak 100
190-02102-00 Rev.4
4.8.2.1 Usage
The Aircraft Copy/Fleet Copy operation is carried out as a two-step process; system
export and system import. There are two cases to be considered for system import.
Import into the same system: When the source and target G1000 NXi system has the
same system ID, system import is supported without requiring special permissions or an
enablement card. This helps to reload the bench/airframe with multiple software/
configuration/option baselines or can function as a system recovery card. The OEM
engineering team can carry out this operation on its own.
Import to a different system/systems: System copy from one G1000 NXi system to a
different (but identically equipped) G1000 NXi system has to be carried out by a Garmin
representative. Garmin can assist in this activity for exceptional cases that require issue
recreation or troubleshooting on a G1000 NXi system with different system ID.
4.8.2.2 System Export
The software/configuration/option for any source setup can be easily copied to a Garmin
approved blank SD card using configuration mode interface. Please get in touch with the
Garmin sales person to order the Garmin approved SD cards. The actions required for
export process are as follows:
1. Insert a blank Garmin approved SD card into the PFD top slot.
2. Apply system power the G1000 NXi system in configuration mode. Verify all
Garmin LRUs are online.
3. From the PFD, navigate to System Status page.
4. Press the SYS Export softkey and wait until a completion notification is displayed.
G1000 NXi system displays will export this in 1-2 min.
The system will export two files to the SD card: sys_export.zip and export_info.gca.
These files are password protected by the system. It is not required to open these files
for the System Copy feature. The files generated using the system export mechanism
can be optionally archived in order to create a System Recovery source.
4.8.2.3 System Import
The card generated using the system export mechanism can be used to load the setup
on a target system. The procedure for system import operation is as follows:
Import into the same G1000 NXi system (same system ID) is supported
without any restriction. However, import into a different G1000 NXi system
(different system ID) will require assistance from Garmin.
To Next Page
Loading...
Need help?
General
