Garmin G1000 Line Maintenance Manual

______________________________________________________________________________
____________________________________________________________________________
LMM for the Kodiak 100 Page 3-3
190-02102-00 Rev.4
Follow these steps to load the digital signature update before loading a 006-B2634-0(X)
loader card when required per the conditions above.
1. Download the digital signature update executable program Garmin P/N 006-
B3071-01 from the Garmin Dealer Resource center. Run the program to make an
SD card for use in the aircraft.
2. Open the PFD1, MFD, and PFD2 circuit breakers.
3. Place the digital signature update card in the top slot of the display that requires
the update.
4. Hold the ENT key on the display and restore power by closing the circuit breaker.
5. When the words INITIALIZING SYSTEM appear in the upper left corner of the
display, release the ENT key.
6. Follow the on-screen prompts to update system files and boot block software.
7. When the load is complete, open the display circuit breaker and remove the card
from the top slot.
8. Repeat steps 3 - 7 for all displays that require the update.
Uncontrolled if Printed

Garmin G1000 Specifications

General

Display Type	LCD
Primary Flight Display (PFD)	Yes
Multi-Function Display (MFD)	Yes
Terrain Awareness	Yes
Autopilot Integration	Yes
Integrated Flight Deck System	Yes
Weather Radar	Optional
Traffic Advisory System (TAS)	Optional
Terrain Awareness and Warning System (TAWS)	Yes
Resolution	1024 x 768 pixels
Weather Data	Yes
Navigation	Yes
AHRS	Yes
Air Data Computer (ADC)	Yes
Interfaces	ARINC 429, RS-232
Certification	TSO certified
Traffic Information	Optional (requires ADS-B or TCAS)