268
Chapter 16: Troubleshooting
www.gateway.com
■ Try a different diskette. Occasionally diskettes are flawed and cannot be
read by the diskette drive.
You see a “Disk is full” error message
■ Delete unnecessary files on the diskette.
■ Try a different diskette. Occasionally diskettes are flawed and cannot be
read by the diskette drive.
■ Run Error checking on the diskette. For more information, see “Checking
the hard drive for errors” on page 227. If errors are detected and corrected,
try using the diskette again.
You see a “Non-system disk”, “NTLDR is missing”, or “Disk error”
error message
■ Eject the diskette from the diskette drive, then press ENTER.
■ Make sure that the diskette you are using is IBM-compatible.
The diskette drive status indicator is lit continuously
■ Remove the diskette from the drive. If the indicator stays on, try restarting
your notebook.
Display
The screen is too dark
■ Adjust the brightness using the system keys. For more information, see
“System key combinations” on page 24.
The screen resolution is not correct
■ Change the screen resolution from the Display Properties dialog box. For
more information, see “Adjusting the screen resolution” on page 182.
The text on the display is dim or difficult to read
■ Adjust the brightness and contrast using the system keys. For more
information, see “System key combinations” on page 24.
■ Change the display settings. For more information, see “Adjusting the
screen and desktop settings” on page 180.
■ Move your notebook away from sources of electrical interference, such as
televisions, unshielded speakers, microwaves, fluorescent lights, and metal
beams or shelves.
To Next Page
Loading...
Need help?
General
