www.gateway.com
45
Replacing the memory card
reader
To replace the memory card reader:
1 Remove the front bezel by following the instructions in
“Removing the front bezel” on page 37.
2 Firmly press the top bezel release tab. The release tab is
in the top of the case, between the power supply and the
optical drive.
3 Slide the top bezel toward the back of the computer
about 3/4 inch, then remove it from your computer.
Tools
You need a Phillips screwdriver to replace the memory card reader.
Tip
The top bezel is the plastic piece that forms the top of your
computer case. You must remove it to perform maintenance on the
memory card reader.
Top bezel release tab
To Next Page
Loading...
Need help?
General
