Gateway MG1 User Manual

CHAPTER 4: Troubleshooting
156
Symptom-to-FRU error messages
LCD
Power
F4h 1 Output one beep before boot
F5h Boot to Mini DOS
F6h Clear Huge Segment
F7h Boot to Full DOS
Symptom / Error Action in Sequence
■
The LCD backlight doesn't work.
■
The LCD is too dark.
■
The LCD brightness cannot be adjusted.
■
The LCD contrast cannot be adjusted.
■
Run “Load Setup Defaults” using the BIOS Setup Utility, then reboot
the notebook.
■
Reconnect the LCD connectors.
■
Test or replace the keyboard (if contrast and brightness function key
doesn't work).
■
Check the LCD inverter ID.
■
Test or replace the LCD cable.
■
Test or replace the LCD inverter.
■
Test or replace the LCD.
■
Test or replace the system board.
■
The LCD screen is unreadable.
■
Missing pels in characters.
■
The screen appears abnormal.
■
The wrong color is displayed.
■
Reconnect the LCD connector.
■
Check the LCD inverter ID.
■
Test or replace the LCD cable.
■
Test or replace the LCD inverter.
■
Test or replace the LCD.
■
Test or replace the system board.
The LCD is displaying extra horizontal or
vertical lines.
■
Check the LCD inverter ID.
■
Test or replace the LCD cable.
■
Test or replace the LCD inverter.
■
Test or replace the LCD.
■
Test or replace the system board.
Symptom / Error Action in Sequence
The notebook shuts down during operation.
■
Test the power source (battery pack and power adapter). See
“Testing the power system” on page 145.
■
Test or replace the battery pack.
■
Test or replace the power adapter.
■
Test or replace the system board.
The notebook doesn’t turn on.
■
Test the power source (battery pack and power adapter). See
“Testing the power system” on page 145.
■
Test or replace the battery pack.
■
Test or replace the power adapter.
■
Test or replace the system board.
Code Beeps

Gateway MG1 Specifications

General

Brand	Gateway
Model	MG1
Category	Laptop
Language	English