CHAPTER 3: Replacing notebook components
66
Replacing the CMOS battery
Tools you need to complete this task:
v
Screws removed during this task:
To replace the CMOS battery:
1 Complete the steps in “Preparing the notebook” on page 55.
2 Remove the optional IEEE 802.11 wireless card by following the instructions in
“Replacing the IEEE 802.11 wireless card” on page 63.
Important
Use only CMOS batteries designed for this Gateway notebook.
Flat-blade driver Scribe or non-marring tool- OR -
Phillips #0 screwdriver
2 black M2×3 (IEEE
802.11 wireless card)
CMOS
battery
bay
To Next Page
Loading...
