GCC Technologies X380 - Operating Environment

NOTE
Each LaserPro laser machine is shipped with a single pair of safety goggles. If
additional safety goggles are required, please contact GCC directly or an authorized
GCC distributor. If you wish to purchase one on your own, please make sure the safety
goggles meet these requirements:
190 - 398 nm OD5+
10,600 nm OD5+
Visible Light Transmission: 92.9%
 Connect the machine to a properly grounded power outlet. Ensure the voltage of the
power source is identical to the voltage of the machine.
 Do not open the laser access panel when the machine is plugged in.
 Do not attempt to modify or disassemble the laser module.
 Do not attempt to remove or modify any component of the machine’s laser interlock
safety system.
 Ensure the immediate work area of the machine is well-ventilated. Odors, vapors, and
dust are byproducts generated during the laser cutting process. An exhaust system,
vacuum cutting box, and honeycomb table are recommended. Please contact GCC or
your local GCC distributor for more information.
 Do not laser heat-sensitive surfaces or materials that may generate toxic fumes, such as
PVC and Teflon.
 Resulting debris from laser cutting are very dangerous and may cause fire hazard.
 DO NOT leave debris and scraps inside laser machine after job finished. Must keep
machine clean after job finished.
Regularly clean and maintain your machine according to our cleaning and maintenance
instructions. Doing so will ensure a machine that will operate effectively and safely over a
long period of time.
1.6 Operating Environment
Please follow the guidelines when considering a suitable location to set the LaserPro X380.
Improper work environments may lead to operational malfunction and/or unsafe working
conditions. The LaserPro X380 should be placed and operated in a standard office-type
environment.
 Avoid environments where the machine is exposed to high levels of dust,
temperature (temperatures exceeding 30°C or 85°F) or humidity (humidity
exceeding 70% or where the ambient temperature is near the dew point).
 Avoid small, enclosed areas with poor ventilation.
 Avoid areas with high levels of noise and electrical noise.
 Select a location that is large enough to accommodate the LaserPro X380, an
exhaust system, a computer and a work or storage table.
 Select a location in which the ambient temperature remains between 15°C and
30°C (60°F to 85°F).