GCC Technologies X380 - Smartbox Option

76 232001250G(06)
7.3 SmartBOX Option
The SmartBOX is an innovative combination of a cutting box, honeycomb table, and material support stands.
During the cutting and engraving process, unwanted scrap, dust, and vapor byproducts are left behind. The
cutting box collects the larger scrap byproducts while venting out the smaller dust particles, vapors, and smoke
to minimize excess buildup on the machine, worktable, and your project. The SmartBOX allows you to
maintain a clean worktable and minimizes backside burning of your media, whether you are working with thick
and firm materials or thin and flexible materials.
SmartBOX Components
Cutting Box
Honeycomb Table
Material Support Stands
Thumb Screws
It is highly recommended that you use different setups of the SmartBOX depending on the physical properties of
the material you will be working with. Here is the recommended SmartBOX component setups based on your
working material.
Component
Application
Cutting Box
Honeycomb Table
Material Support
Stands
Thin, Flexible Materials
Required
Required
Not Required
Thick, Firm Materials
Required
Not Required
Required
Action
Suggestion setups
Engraving
NO Smart Box
Light cutting
honeycomb table
Thick cutting
Cutting box + Support
Thin textile/fabric module
smart box
NOTE
Advanced users may choose to try other component setups to suit their particular
engraving / cutting techniques or working material. Feel free to explore different ways to
setup the various SmartBOX components to adapt to the results you wish to achieve.