GCC Technologies X380 - The Laserpro X380 Print Driver; Page Setup and Orientation

52 232001250G(06)
5.2 The LaserPro X380 Print Driver
With the LaserPro X380 print driver successfully installed, you will need to adjust the printer and page size
default settings before you can begin editing and completing jobs. By doing so, you will be setting the work area
in your graphics software to match the LaserPro X380’s worktable area.
NOTE
Please make sure X380 is set to the default printer before proceeding to the page and layout
setup.
Ensure that the LaserPro X380 has been selected as the DEFAULT PRINTER. You can do so by going into your
Windows Control Panel  Printers and Faxes.
If LaserPro X380 is not selected as DEFAULT PRINTER, you may set it up through the graphics software as well.
The following is taking Corel Draw as example of how to set up LaserPro X380 as the Printer.
1) From the primary menu, click FILE  PRINT SETUP.
2) From the navigation bar Name, click X380  OK
5.2.1 Page Setup and Orientation
The first thing you must do before working with the LaserPro X380 Print Driver will be to make sure the page and
layout settings are properly configured within your graphics software. You will need to access and edit the Page
Setup or Layout page of your graphics software to set your graphics software’s page layout to match the LaserPro
X380’s work table’s dimensions and orientation.
From your graphic software’s Page Setup page:
 Set the page orientation in the graphics software to Landscape mode.
 Set page size horizontal length to 900 mm (36 inches) and vertical height to 600 mm (24 inches).