Tips for engraving 3D graphics
LaserPro Application Lab provides a few reminders that may require your attention during the
3D engraving in order to improve the result of the engraving.
Turn on the Air Assist function
When the engraving is done along with Air Assist, the depth of the engraving would be deeper.
Set Air assist inside the driver by checking the box.
Polish
Dust will accumulate during the engraving when acrylic is engraved. The acrylic may be
polished with Polish after the engraving. After the processing, don’t remove the engraved
object. Use the Control Panel to lower the platform (for about 7~8 mm) and then engrave once
again to achieve the better finish.
After engraving the wooden objects, please use a toothbrush with some clean water to remove
the dust on top of the object.
To Next Page
Loading...
