- 88 - 232001250G(06)
software driver or the control panel.
3. Please check if the laser power connector is loose.
4. For safety purpose, the laser beam will not be generated when the top or front door is opened
unless you short the connector of the magnetic switches.
5. Check water level or temperature of water cooler for the machine. If over-heated, laser beam will
shut down automatically.
NOTE: Unplug the machine before examining the mirrors, lens, motion system or any other part of the
laser system.
Other Problems
Graphic Was Clipped…” Message
The size or location of graphic image may be bigger or beyond legal working area.
Do not place graphic object, especially vectors, right from (3,0) origin position, or 0 at either x or y rail of
working area on application software, Corel Draw for instance, even vector line’s width has been set to
the thinnest. Because at thinnest line width, it still goes beyond the boarder and causes the error.
If the message appears randomly but frequently even image object is smaller or within the legal boarder,
check or change DRAM module, a bad contact or faulty DRAM could cause such error.
Auto Focus Pin is Not Functioning
The focus pin could be stocked by greasy residue that coats on it. Clean the probe with alcohol or
acetone.
Check the cable of focus pin, there might be a bad contact or breakage.
To Next Page
Loading...
