GE Interlogix Concord Security System User Manual

Concord 36
DTMF Dialing (02004)
Phone Options-Global (Default = on)
This setting determines whether the panel uses DTMF tones (on) or
pulse (off) for dialing programmed phone numbers.
¾
To turn DTMF Dialing off or on:
1. With the display showing DTMF DIALING OFF/
ON (current setting), press 1 (off) or 2 (on). The
display flashes the entered setting.
2. Press # and the display shows the new setting.
Dialer Abort (02005)
Phone Options-Global (Default = on)
This setting determines whether or not the user can stop a panel before it
sends a false alarm to the central station.
Note
Fire alarm reports to the central station cannot be aborted.
When this feature is on, alarm reports from sensors in groups 00–20, 34,
and 35 can be aborted. To abort the dialing attempt, the user must enter 1 +
user
code within the Dialer Abort Delay time setting (defaulted to 30 sec).
Cancel and restoral reports from these sensor groups are aborted at the
same time. The following reports can also be aborted.
• System Alarm Tamper/Cancel
• No Activity Alarm/Cancel
• Touchpad Police and Auxiliary Panic/Cancel
• Recent Closing and Two Trip Error
¾
To turn Dialer Abort off or on:
1. With the display showing DIALER ABORT
OFF/ON
(current setting), press 1 (off) or 2
(on). The display flashes the entered setting.
2. Press # and the display shows the new set-
ting.
Dialer Abort Delay (02006)
Phone Options-Global (Default = 30 sec.)
This setting determines how much time the user has to abort a panel
report.
Note
For UL Listed systems, the combined time for the Entry Delay (0310/0320)
and Dialer Abort Delay must not exceed 60 seconds.
¾To change the Dial Abort Delay:
1. With the display showing DIAL ABORT DELAY nn
SECS (current setting), enter the desired time
(15–120s). The display flashes the entered set-
ting.
2. Press # and the display shows the new setting.
Cancel Message (02007)
Phone Options-Global (Default = on)
This setting determines whether or not the panel displays a cancel mes-
sage after the user disarms the system to clear an alarm condition.
¾
To turn Cancel Message off or on:
1. With the display showing CANCEL MESSAGE
OFF/ON
(current setting), press 1 (off) or 2
(on). The display flashes the entered setting.
2. Press # and the display shows the new setting.
Pager Delay (02008)
Phone Options-Global (Default = 15 sec.)
This setting determines how long a report is delayed to a pager, after the
panel dials the pager number.
Note
The Pager Delay time should not be set below 5 seconds, unless absolutely
necessary.
¾To set the Pager Delay time:
1. With the display showing PAGER DELAY nn SECS
(current setting), enter a delay time (0–30).
The display flashes the entered setting.
2. Press # and the display shows the new setting.

GE Interlogix Concord Security System Specifications

General

Brand	GE Interlogix
Model	Concord Security System
Category	Security System
Language	English