2.3.17 Group 2 Menu
2.3.17.1
Edit Settings
2.4 Configuration Flowcharts
2.4.1 Main Menu
2.4.2 View and Edit Settings
2.4.3 View System Data Menu Settings
2.4.4 View Records Menu
2.4.4.1 View Content
2.4.4.2 View Fault Records
2.4.4.3 View Event Records
2.4.4.4 View Maintenance Records
2.4.4.5 View Alarm Records
2.4.5 Measurement Menu
2.4.5.1 View Measurements
2.4.6 CB Control Menu
2.4.6.1 View/Edit Settings (if all settings are disabled)
2.4.6.2 View/Edit Settings (if all settings are enabled)
2.4.7 Date and Time Menu
2.4.7.1 View/Edit Settings (if all settings are disabled)
2.4.7.2 View/Edit Settings (if all settings are enabled)
2.4.8 Configuration menu
2.4.8.1 View/Edit Settings
2.4.9 Transformer Ratios Menu
2.4.9.1 View/Edit Settings
2.4.10 Record Control Menu
2.4.10.1 View/Edit Settings
2.4.11 Communication Menu
2.4.12 View/Edit settings
2.4.13 I/O Configuration Menu
2.4.14 View/Edit Settings
2.4.15 O/P Relay Configuration Menu
2.4.15.1 View/Edit Settings
2.4.16 Disturbance Record Menu
2.4.16.1 View/Edit Settings
2.4.17 Commissioning Test Menu
2.4.17.1 View/Edit Settings
2.4.18 Group1 Menu
2.4.18.1 View/Edit Settings
2.4.18.2 Group1 System Configuration Submenu
2.4.18.3 Group1 Overcurrent Submenu
2.4.19 Negative Sequence Overcurrent Menu
2.4.19.1 View/Edit Settings (If setting is disabled)
2.4.19.2 View/Edit Settings (If setting is enabled for IEC curve)
2.4.19.3 View/Edit Settings (If setting is enabled for IEEE curve)
2.4.19.4 View/Edit Settings (If setting is enabled for DT)
2.4.20 Broken Conductor Menu
2.4.20.1 View/Edit Settings (If setting is disabled)
2.4.20.2 View/Edit Settings (If setting is enabled)
2.4.21 Group 1- Earth Fault 1 Submenu
2.4.21.1 View/Edit Settings (If setting is disabled)
2.4.21.2 View/Edit Settings (If setting is enabled for IEC curve)
2.4.21.3 View/Edit Settings (If setting is enabled for IEEE curve)
2.4.21.4 View/Edit Settings (If setting is enabled for DT)
2.4.22 Group 1-Earth Fault 2 Submenu
2.4.22.1 View/Edit Settings (If setting is disabled)
2.4.22.2 View/Edit Settings (If setting is enabled for IEC curve)
To Next Page
Loading...
Need help?
General
