GE Agile P50 Series User Manual

P50 Agile P153
5 Configuration
P153/EN M/B
5-9
SYSTEM DATA
2.3.2 Main Menu Contents
SYSTEM DATA
Password protected window for “SYSTEM DATA’’ setting i.e. Language,
Description, Model Number, Serial Number, Software Version,
Frequency, USB Address, USB Parity, USB Baud Rate, Password,
Active Group, Opto I/P Status, Relay O/P Status. CB Open/Close, Opto
I/P and Config Port.
VIEW RECORDS
This menu is to view Fault Record, Event Record, Maint Record and
Alarm records.
MEASUREMENTS
This menu displays the measurements values of various parameters (i.e.
Phase current, measured and derived earth current, negative, positive
phase sequence current and I2/I1 ratio as per per phase / earth CT ratio,
TC (Trip Counter), BOC (Breaker Operation Counter), BOT (Breaker
Operating Time) and Th State (Thermal State).
CB CONTROL
Password protected window for “CB CONTROL” settings i.e. TCS
Alarm, TCS Timer, CB Open S’vision (Enabled / Disabled), CB Open
Time, CB Open Alarm (Enabled / Disabled), CB Open Oper, CB Control
By, Close Pulse Time, Open Pulse Time .
DATE AND TIME
Password protected window for
“DATE AND TIME’’
settings i.e. Local
Time Enable, Local Time Offset. DST Enable, DST Offset, DST Start,
DST Start Day, DST Start Month, DST Start Mins, DST End, DST End
Day, DST End Month, DST End Mins, RP Time Zone, SET Hours, SET
Minutes, SET Seconds, SET Date, SET Month and SET Year.
CONFIGURATION
Password protected window for
“CONFIGURATION’’
settings i.e.
Restore Defaults, Active Settings, Copy From, Copy To, Setting Group 1
(Enabled/Disabled), Setting Group 2 (Enabled/Disabled), System Config
(Enabled/Disabled), Overcurrent (Enabled/Disabled), Neg Sequence
O/C (Enabled/Disabled), Broken Conductor (Enabled/Disabled), Earth
Fault 1 (Enabled/Disabled), Earth Fault 2 (Enabled/Disabled), Thermal
Overload (Enabled/Disabled), Cold Load Pickup (Enabled/Disabled),
Measure’t Setup, UnderCurr Prot (Enabled/Disabled), CB Fail
(Enabled/Disabled) and Setting Values.
TRANS. RATIOS
Password protected window for “TRANS. RATIO ’’ settings i.e Phase
CT Primary, Phase CT Sec’y, E/F CT Primary and E/F CT Secondary.
RECORD CONTROL
Password protected window for “RECORD CONTROL’’ settings i.e.
Clear Events (Yes/No), Clear Faults (Yes/No), Clear Dist Recs (Yes/No),
Clear Maint (Yes/No), Thermal Reset (Yes/No).

GE Agile P50 Series Specifications

General

Brand	GE
Model	Agile P50 Series
Category	Relays
Language	English