Connector illustration
The illustration below shows where the connectors are located on the ÄKTA pure instru-
ment. For connectors on the computer equipment, refer to the manufacturer´s documen-
tation.
Connect power to the ÄKTA pure
instrument
Follow the instruction below to connect power to the ÄKTA pure instrument.
ActionStep
Select the correct power cord to be used. Each instrument is delivered with
2 alternative power cords:
1
•
Power cord with US-plug, 2 m
•
Power cord with EU-plug, 2 m
Discard the power cord that is not to be used.
Connect the power cord to the Mains IN input connector on the back of the
instrument and to a grounded wall outlet 100-240 V, ~ 50/60 Hz.
2
78 ÄKTA pure Operating Instructions 29022997 AF
4 Installation
4.2 Hardware installation
4.2.3 Connect system units
To Next Page
Loading...
