4-10 170 Series Monitor Revision C
2000947-004
Setup Procedures: Customizing the Monitor
Customizing the Monitor
User Setup Mode
The monitor includes a user setup mode where you can:
enable/disable alarm functionality
set the high alarm limit for the fetal heart rate
set the low alarm limit for the fetal heart rate
set the alarm volume
set the time and date
Service Setup Mode
The monitor includes a service setup mode where you can access all user setup
modes as well as the following:
enable/disable fetal movement detection
(if purchased and installed)
select the language for printing on the strip chart paper
set the chart speed
select the paper scale
choose a communication mode for each rear panel communications port
set the baud rate for each communications port
select the remote mark annotation style
enable/disable fetal heart rate offset
(Models 172, 173, and 174 only)
enable/disable ECG artifact elimination
(Models 173 and 174 only)
enable/disable heartbeat coincidence
(Models 172, 173, and 174 only)
set the default UA reference value
perform a recorder alignment test
print the software version number along with a summary of all current
configuration settings
To Next Page
Loading...
Need help?
General
