D-4 Dash 2500 Patient Monitor 2042480-001 C
Maintenance: Maintenance, Cleaning, and Calibration
Monitor Exterior
The exterior surfaces of the Dash 2500 Patient Monitor may be cleaned with a
dampened, lint-free cloth. Use one of the following approved solutions:
Mild soap (diluted)
Commercial diluted bleach solution or bleach wipe, such as Dispatch
®
Brand Hospital Disinfectant with Bleach Single-Piece Towels
Commercial diluted ammonia solution
Wipe off cleaning solutions with a clean, dry cloth
Never use the following cleaning agents:
Abrasive cleaners or solvents of any kind
Acetone
Ketone
Alcohol-based cleaning agents
Betadine
Quaternary ammonium disinfectants such as Virex, Sani-Wipes, Ascepti-
Wipes, or products containing similar active ingredients to these should be
avoided.
Cleaning solutions containing wax
Never pour or spray water or any cleaning solution on the equipment or
permit fluids to run behind switches, into connectors, into the recorder, or
into any ventilation openings in the equipment.
Display
To clean the display screen, use a soft, clean cloth dampened with a glass
cleaner. Never spray the glass cleaner directly onto the display, and never use
alcohol or hospital disinfectants like Cidex or Betadine.
Failure to follow these cleaning recommendations may melt, distort, or dull the
finish of displays and cases; blur lettering on labels; embrittle cases and lead to
cracks and breakage; or cause equipment failures. Use of non-approved
cleaning agents is considered abuse and is not covered under warranty.
NOTES
Do not use acetone on any part of the Monitor.
Do not immerse or spray any liquids directly on the Monitor.
Always verify the efficacy of the recommended cleaning agents. GE
Medical Systems Information Technologies does not guarantee
infection control based on the proper usage of these cleaning agents.
To Next Page
Loading...
Need help?
General
