GE Druck ADTS 405 R/F Mk2 - Page 56

Chapter 3. OPERATION
38 | ADTS 405 Mk2 Instruction Manual-English © 2015 General Electric Company – All rights reserved.
FULL SET-UP
Key/selection Function and comments
SETUP + KEY PRESS
[UNITS]
Select units
[LIMITS]
[NEXT]
[PREV]
[SAVE]
Step through available units
PyppwixytwipigxihmrgsrƉkyvexmsr
Select displayed units
Step back though available units
Select set of limits
[OSC]
[NEXT]
[PREV]
[SEL]
(aircraft 1\aircraft 2 ...)
[Ps]
As NEXT, in reverse order
Select displayed limit set
Oscillate about aim
For Ps channel
[AMPL]
Data Entry
[START]
[STOP]
[FREEZE]
[AMPL/FREQ]
Data Entry
[FREQ]
[Pt]
[MORE]
As for Ps channel
Selects Ps only, Pt only or Dual channel control
Select single, dual or triple display
(SINGLE\DUAL\TRIPLE\ENCODER)
[CONTROL]
[Ps Pt DUAL]
[DISPLAYS/OPTIONS]
[
DISPLAY TYPE]
As NEXT, reverse order
[NEXT]
[PREV]
[SAVE]
[I/O SETUP]
Save displayed Display Type
Configure Ethernet
[ENET SUPER]
[-]
Supervisor node Ethernet parameters
IP Address
Setup fixed IP Address
[FIXED IP]
[ADDR]
[MASK]
Subnet Mask
Broadcast
[BCST]
Menu option not available. DHCP select in CONFIG only
Confirm active IP settings
[-]
[SHOW ACTIVE]
[ENET COMMS]
Communications node Ethernet parameters
See option manual
Confirm active IP settings
[-]
[SHOW ACTIVE]
[OPTIONS]
Menu option not available. DHCP select in CONFIG only
Close output val
ves
Menu option not available. Fixed IP select in CONFIG
only
Open output valves
Start self test
[CLOSE O/P VALVES]
[OPEN O/P VALVES]
[SYSTEM SELF TEST]