User Manual Druck DPI612
Page 14 of 105 [EN] English – 109M4017 Revision -
• Wipe the battery terminals with a clean dry cloth if they become
dirty.
• If you find rust, a bad odour, overheating and/or other irregularities
when using the battery pack for the first time, return it to your
supplier or vendor.
• For further information contact the nearest distributor or
representative.
• Retain the original product literature for future reference.
PRESSURE WARNINGS 1.7
• It is dangerous to attach an external source of pressure to a
DPI612 pressure station. Use only the internal mechanisms to set
and control pressure in the pressure station.
• To prevent a dangerous release of pressure, isolate and bleed the
system before disconnecting a pressure connection.
• To prevent a dangerous release of pressure, make sure that all the
related pipes, hoses and equipment have the correct pressure
rating, are safe to use and are correctly attached.
• To prevent damage to the DPI612 calibrator, only use it within the
specified pressure limits.
• Do not exceed the maximum pressures stated in the appropriate
component manual for the unit under test.
• Reduce pressure at a controlled rate when venting to atmosphere.
• Carefully de-pressurize all pipes to atmospheric pressure before
disconnecting and connecting to the unit under test.
• Always wear appropriate eye protection when working with
pressure.
To Next Page
Loading...
