User Manual Druck DPI612
Page 21 of 105 [EN] English – 109M4017 Revision -
No.
Description
PFP models only: Pneumatic refill valve. Close it to seal off the device
pressure and refill the pressure mechanism.
6 CH1 connectors for: Voltage (V); Current (mA+, mA-); Switch operation.
Isolated CH2 connectors for: Voltage (V); 24 V loop power supply (24
Vo).
8 Liquid Crystal Display (LCD): Color display with touch-screen. To make
a selection, lightly tap on the applicable display area.
Optional accessory (not shown): Pressure connection for a relief valve
(PRV). A blanking plug is standard.
10 Pressure and electrical connections for a PM620 module (not shown):
DPI612 models PFX and PFP: Seal the pressure connection with a
blanking plug (Part: IO620-BLANK) or a PM 620 module.
DPI612 HFP models only: The pressure connection seals itself.
11
HFP models only: Hydraulic refill valve (not shown): Close it to seal off
the device pressure and refill the pressure mechanism with fluid.
13 +5 V DC power input socket. This supply also charges the optional
battery pack.
14 USB type A connector for connections to external peripherals (USB
flash memory or optional external modules).
15 USB mini-type B connector for communication with a computer.
1.10.2 Test Port
To attach the device under test, the test port uses “Quick
fit” pressure adaptors; See Section 1.10.10. These are easy
to remove, change and install; See Section 2.1.1
(Attach/Remove the device under test).
Test port
To Next Page
Loading...
