GE ImageQuant LAS 4000 - Page 46

5
Holding the latch with one hand, remove the Epi light by pulling it gently outwards.
6
Lift up and remove the Epi light.
7
Before installing the new Epi light, ensure that the latch is sprung open (upwards).
8
Hook the hanger located on top of the Epi light to the top edge of the Epi light base.
1
2
ActionNo.
Two guide holes are located on the back of the Epi light base.1
Slide the hook after attaching the guide pins to the guide holes.2
46 Getting Started with ImageQuant LAS 4000 28-9607-59 AB
4 Operation
4.2 Preparation
4.2.2 Preparing the ImageQuant LAS 4000 for exposure