GE HEALTHCARE
D
IRECTION 5305880-100, REVISION 3 LOGIQ™ 100 PRO SERVICE MANUAL
Page TOC-6
10-6-6 Probe Leakage Current Test 10-19
10-6-6-1Definition....................................................................................................... 10-19
10-6-6-2Generic Procedure for Leakage current ....................................................... 10-19
10-6-6-3Meter Procedure Using Dale Meter to measure leakage current ................. 10-19
Meter Procedure using Probe Adapter to measure Probe isolation(Sink) Current 21
Section 10-7 When There's Too Much Leakage Current......................... 10-23
State: RELEASE - Document is released and under formal Change Control. Changes are subject to the ECR/ECO Process.
See the GEHC Myworkshop System to determine the status of this document.
Approved Document - 5305880-100TPH_r3.pdf Page 17 of 197
To Next Page
Loading...
