GE HEALTHCARE
D
IRECTION 5305880-100, REVISION 3 LOGIQ™ 100 PRO SERVICE MANUAL
Chapter 1 - Introduction Page 1-21
1-5-8 Electrostatic Discharge (ESD) Prevention
Section 1-6Customer Assistance
This system is not repairable by the customer. If this equipment does not work as indicated in the
Operator's Manual, please contact your service support center. If the service engineer needs
additional information to repair this equip ment, please contact any relevant addresses given below:
1-6-1 System Manufacturer
DO NOT TOUCH ANY BOARDS WITH INTEGRATED CIRCUITS PRIOR TO TAKING THE
NECESSARY ESD PRECAUTIONS:
1.) Always connect yourself, via an arm-wrist strap, to the advised esd
connection point located on the rear of the scanner (to the right of the
power connector).
2.) Follow general guide lined for handling of electrostatic sensitive
equipment.
WARNING
WIPRO GE HEALTHCARE - INDIA
WIPRO GE HEALTHCARE PVT., LTD.
ULTRASOUND GROUP.
PLOT # 4, KADUGODI INDUSTRIAL AREA,
SADARAMANGALA,
BANGALORE 560067, INDIA
TEL: (91) 80-2845-2923
FAX:(91) 80-2845-2924
Ultrasound Tech Support - India : +(91) 1800114567
Table 1-6 System Manufacturer
State: RELEASE - Document is released and under formal Change Control. Changes are subject to the ECR/ECO Process.
See the GEHC Myworkshop System to determine the status of this document.
Approved Document - 5305880-100TPH_r3.pdf Page 38 of 197
To Next Page
Loading...
Need help?
General
