GE HEALTHCARE
D
IRECTION 5305880-100, REVISION 3 LOGIQ™ 100 PRO SERVICE MANUAL
Chapter 3 - Installation Page 3-1
Chapter 3 Installation
Section 3-1Overview
3-1-1 Purpose of Chapter 3
This chapter contains information needed to install the unit. Included are references to a procedure
that describes how to receive and unpack the equipment and how to file a damage or loss claim.
How to prepare the facility and unit of the actual installation, and how to check and test the unit,
probes, and external peripherals for electrical safety are included in this procedure. Also included
in this section are guidelines for transporting the unit to a new site.
CONTENTS IN CHAPTER 3
3-1-2 Average Installation Time
Table 3-1 Contents in Chapter 3
Section Description Page Number
3-1 Overview
3-1
3-2 Receiving and Unpacking the Equipment
3-3
3-3 Preparing for Installation
3-5
3-5 Completing the Installation
3-6
3-6 System Configuration
3-17
3-7 Paperwork
3-28
Description Average
Installation
Time
Comments
Unpacking the scanner 20 Minutes
Scanner wo/options 40 Minutes Dependant on the configuration that
is required
Table 3-2 Average Installation Time
State: RELEASE - Document is released and under formal Change Control. Changes are subject to the ECR/ECO Process.
See the GEHC Myworkshop System to determine the status of this document.
Approved Document - 5305880-100TPH_r3.pdf Page 46 of 197