GE LOGIQ E9

GE
D
IRECTION 5535208-100, REV. 2 LOGIQ E9 SERVICE MANUAL
Chapter 3 LOGIQ E9 Setup 3 - 41
3-9-3 How to Get the LOGIQ E9 to Recognize another Device on the Network
Table 3-9 Utility -> Connectivity -> Device screen
1.
Press Add. The system creates a device called “NewDevice.”
2.
Change the name to one of your choosing.
3.
Enter the IP address of the device.
Ping / Smiley
4.
Save your changes and then press Ping. A “Smiley Face” indicates
successful communication between your LOGIQ E9 and the device. A “Frown”
indicates failed communication. Check the following:
• Is the device running?
• Is it connected to the network?
• Did you enter the right IP address?