GE LOGIQ E9 Service Manual

GE
D
IRECTION 5535208-100, REV. 2 LOGIQ E9 SERVICE MANUAL
8 - 16 Section 8-4 - Loading / Reloading / Upgrading the Software
4. Press any key to continue; or to abort,
remove the disk from the drive and press
CTRL-C.
The System Software Load Instruction
window displays.
System Software load
instruction (R.4)
5. Choose Option 1 to perform a complete
Software installation, all data will be erased.
Choose Option 2 to install Software on C
partition only. Only data on C partition will
be erased.
Choose Option 1.
The Software loader program will begin to
launch and the following warning will
appear:
You are about to reload the
entire disk. If you DO NOT want
to do this, remove the CDROM from
the CDROM drive and Press
"CTRL-C" now to exit and power
cycle your system to restart
without overwriting your disk
drive's current contents.
Press any key to continue...
The Software loader program will continue
to launch.
In R5 or later, at some point the system will
prompt to insert Disk #2. Follow the screen
instructions.
The Symantec Ghost window displays.
After any key to boot DVD Ghost
Ghost wait until next
Symantec Ghost Window
WARNING
WARNING
DO NOT interrupt the software loading at any time.
Table 8-4 Software Load - R4 or later
Steps Corresponding Graphic

GE LOGIQ E9 Specifications

General

Type	Ultrasound System
3D/4D Imaging	Yes
Transducer Ports	4 active ports
Connectivity	DICOM, USB, Ethernet
Applications	Abdominal, Vascular, Musculoskeletal, Small Parts, Urology, Pediatric, Cardiac, Obstetrics/Gynecology
Transducers	Linear, Convex, Phased Array, Volume
Doppler Modes	Color Doppler, Power Doppler, Pulsed Wave Doppler, Continuous Wave Doppler
Elastography	Yes
Advanced Features	B-Flow, Volume Navigation
Portability	Cart-based system
Display	19-inch high-resolution LCD monitor