GE
D
IRECTION 5535208-100, REV. 2 LOGIQ E9 SERVICE MANUAL
Chapter 1 Introduction 1 - 19
1-4-4 Electrical safety
1-4-4-1 Safe practices
Follow these guidelines to minimize shock hazards whenever you are using the scanner:
• The equipment chassis must be connected to an electrical ground.
• The unit is equipped with a three-conductor AC power cable. This must be plugged into an approved
electrical outlet with safety ground. A separate power outlet with a 20 amp circuit breaker for 120
VAC for 120V area, 7.5 amp circuit breaker for 220-240 VAC for 220/240V area or 15 amp circuit
breaker for 100 VAC for Japan.
• The power outlet used for this equipment should not be shared with other types of equipment.
• Both the system power cable and the power connector must meet international electrical standards.
1-4-4-2 Probes
Follow these guidelines before connecting a probe to the scanner:
• Inspect the probe prior to each use for damage or degradation to the:
- housing
- cable strain relief
-lens
- seal
- connector pins
- locking mechanism
• Do not use a damaged or defective probe.
• Never immerse the probe connector or adapter into any liquid.
• The system has more than one type of probe port. Use the appropriate probe port designed for the
probe you are connecting.
Connecting a LOGIQ E9 scanner to the wrong voltage level will most likely destroy it.
To Next Page
Loading...
Need help?
General
