GE LOGIQ E9 - Page 481

GE
D
IRECTION 5535208-100, REV. 2 LOGIQ E9 SERVICE MANUAL
Chapter 8 Replacement procedures 8 - 135
8-6-8-1 Upper OP Panel/Touch Panel Assembly removal (cont’d)
Figure 8-44 Upper OP Panel/Touch Panel assembly cables - R4 and earlier
1.
Ribbon Cable from the Operator
Panel, Lower
5.
Bulkhead Board USB Cable 2 (from
bulkhead position furthest from the
OP) in position J25
2.
Trackball Cable from the Operator
Panel, Lower
6.
USB Cable 1 (part of Main Cable) in
position J21
3.
A/N Cable from the A/N Keyboard
7.
USB Cable 2 (part of Main Cable) in
position J22
4.
Bulkhead Board USB Cable 1
(from bulkhead position closest to
the OP) in position J24
8.
Power/On-Off switch (part of Main
Cable) in position J23
NOTICE
Be careful not to pinch any of the cables when installing the 195 Panel/Touch Panel Assembly.