GE
D
IRECTION 5535208-100, REV. 2 LOGIQ E9 SERVICE MANUAL
Chapter 8 Replacement procedures 8 - 137
8-6-8-1 Upper OP Panel/Touch Panel Assembly removal (cont’d)
Table 8-88 Upper OP Panel/Touch Panel Assembly installation (cont’d)
Steps Corresponding Graphic
3. Attach the cables to the Upper OP Panel/
Touch Panel Assembly before installing it
to the system.
9 - Power - ON/OFF (from BEP)
10 - USB - Upper OP Panel (from BEP)
11 - USB - Video (from BEP), if present
Cables to Upper OP
4. Install the Upper OP Panel/Touch Panel
Assembly into the Frame UI Upper. Be sure
the Upper OP Bezel alignment tabs are
positioned, correctly into the slots in the
Lower OP Bezel and Frame UI Upper
Cover.
Upper OP Panel/Touch Panel Assembly
alignment tabs and slots
To Next Page
Loading...
