GE
D
IRECTION 5535208-100, REV. 2 LOGIQ E9 SERVICE MANUAL
8 - 164 Section 8-6 - Replacing Top Console Parts
8-6-11-5 Options Holder installation
1.) If this Options Holder will be supporting a Gel Warmer, place the Gel Warmer in the Options Holder
first and then install the Gel Warmer to the Options holder.
NOTE: Be sure the Gel Warmer cable fits in the cable channels and is not pinched.
2.) Position the Options Holder in place.
NOTE: Be sure the Gel Warmer cable fits in the cable channels and is not pinched.
3.) Install the three screws securing the Options Holder.
4.) Install the Storage Tray or Transvaginal Probe Holder to the Options Holder, if applicable.
Figure 8-47 Screw locations
To Next Page
Loading...
