GE LOGIQ E9 Service Manual

GE
D
IRECTION 5535208-100, REV. 2 LOGIQ E9 SERVICE MANUAL
Chapter 8 Replacement procedures 8 - 167
8-6-12-4 Gel Warmer removal
1.) Remove the Bulkhead Cover.
2.) Disconnect the Gel Warmer cable from (P1) on the back of the bulkhead.
3.) The Gel Warmer cable is routed through the cable channel (1) and the lower frame support (2). Pull
the Gel Warmer cable through the lower frame cable support to free the cable.
4.) Remove the Options Holder (8-6-11 "Options Holder / Left or Right Support replacement" on page
8-162).
5.) Remove the two screws at the Gel Warmer base.
6.) Lift the Gel Warmer out of the Options Holder.
Figure 8-48 Gel Warmer Cable placement
Figure 8-49 Options Holder removed, with Gel Warmer in place

GE LOGIQ E9 Specifications

General

Type	Ultrasound System
3D/4D Imaging	Yes
Transducer Ports	4 active ports
Connectivity	DICOM, USB, Ethernet
Applications	Abdominal, Vascular, Musculoskeletal, Small Parts, Urology, Pediatric, Cardiac, Obstetrics/Gynecology
Transducers	Linear, Convex, Phased Array, Volume
Doppler Modes	Color Doppler, Power Doppler, Pulsed Wave Doppler, Continuous Wave Doppler
Elastography	Yes
Advanced Features	B-Flow, Volume Navigation
Portability	Cart-based system
Display	19-inch high-resolution LCD monitor