GE
D
IRECTION 5535208-100, REV. 2 LOGIQ E9 SERVICE MANUAL
8 - 232 Section 8-9 - BEP (Back End Processor) parts replacement
4.
Remove the two Phillips screws securing
the HDD and Bracket to the BEP frame.
HDD mounting screws
5.
Pull/slide the HDD out of the BEP, and
Bracket to the BEP frame. Slight force may
need to be applied since the HDD fits tightly
into the BEP motherboard.
If the HDD has patient data, leave the HDD
at the site.
Note the HDD installation guides.
HDD removal
HDD installation guides
Table 8-144 HDD removal
Steps Corresponding Graphic
To Next Page
Loading...
