GE
D
IRECTION 5535208-100, REV. 2 LOGIQ E9 SERVICE MANUAL
Chapter 8 Replacement procedures 8 - 265
3. Route the USB Cable through the slot
in the PS.
Firmly, but gently push on the 4D MC
Cover until it is seated in place
(connected) to the PS.
Make sure the USB Cable is still in the
correct position.
Reinstall the three 4D MC Cover
screws.
4.
Put the Main PS into position so it will
be ready to be mounted.
Route the USB cable between the
Targa frame and the BEP.
Table 8-168 4D MC Reinstallation for Lambda PS
Steps Corresponding Graphic
To Next Page
Loading...
