System Setup
3-38 LOGIQ V2/LOGIQ V1 – Basic Service Manual
5610739-100 English Rev.10
How to get the LOGIQ V2/LOGIQ V1 to recognize another Device on
the Network
Table 3-13: Utility ->Connectivity ->Device screen
1 Select Add. The system creates a device called “NewDevice”.
2 Change the name to one of your choosing.
3 Enter the IP address of the device.
4 Save your changes and then press Ping. A “Smiley Face” indicates successful
communication between your
LOGIQ V2/LOGIQ V1 and the device. A “Frown”
indicates failed communication. Check the following:
• Is the device running?
• Is it connected to the network?
• Did you enter the right IP address?
To Next Page
Loading...
