Introduction
1-18 LOGIQ V2/LOGIQ V1 – Basic Service Manual
5610739-100 English Rev.10
Electrical safety
Safe practices
Follow these guidelines to minimize shock hazards whenever
you are using the Ultrasound system:
• To minimize shock hazard, the equipment chassis must be
connected to an electrical ground.
• The Ultrasound system is equipped with a three-conductor
AC power cable. This must be plugged into an approved
electrical outlet with safety ground.
• The power outlet used for this equipment should not be
shared with other types of equipment.
• Both the system power cable and the power connector must
meet international electrical standards
Connecting a LOGIQ V2/LOGIQ V1 to the wrong voltage level
will most likely destroy it.
To Next Page
Loading...
