GE LOGIQ V1

Screen Capture
LOGIQ V2/LOGIQ V1 – Basic Service Manual 8-9
5610739-100 English Rev.10
Reset the Store Key to Customer’s Functionality
If the customer had programmed the Store Key to a function
other than screen capture, restore that functionality recorded in
section ‘Setting the Store Key to Screen Capture’ on page 8-6.
Refer to Figure 8-2 on page 8-5.
1. Press Utility on the control panel.
2. Select Connectivity in the Utility menu.
3. In the Button field, select Store.
4. In the Destinations list, select the service(s) recorded in step
5, See ‘Setting the Store Key to Screen Capture’ on
page 8-6.
5. In the Physical Print Buttons section, select the parameters
related to the service recorded in step 6, see ‘Setting the
Store Key to Screen Capture’ on page 8-6.