CHAPTER 5: IP ADDRESSING IP ADDRESSING
MULTILINK ML3000 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL 5–29
Here is a list of the modules and related settings that can be selected not to default back to
factory default settings.
Kill Config option using CLI
This command is a “hidden command”; that is, the on-line help and other help functions
normally do not display this command. The syntax for this command is:
kill Config
or
kill config save=module command
The kill Config command will default all the Switch settings back to factory defaults, while
the kill config save=module will default all with the exception of module selected.
Available modules are: system, user, acces, port, vlan, ps, mirror, lacp, slp, and igmp.
Name Areas affected
System IP Configuration, Boot mode
User Users settings (e.g. login names, passwords)
Port
Port settings, Broadcast Protection and QoS
settings
STP/RSTP STP, RSTP settings
Port-Security Port Security settings
Port-Mirror Port Mirror settings
VLAN Port/Tag VLAN settings
ACCESS IP-Access and Host Table settings
IGMP IGMP Settings
LACP LACP settings
To Next Page
Loading...
Need help?
General
