GE Multilink ML3000 - Configuration Commands

18–20 MULTILINK ML3000 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
MISCELLANEOUS COMMANDS CHAPTER 18: MISCELLANEOUS COMMANDS
• clear: clears the event log, command history, or screen
•
climode: to set the interactive CLI mode
•
enable: allows to login as another user
•
help
•
more: to set more pipe in screen outputs
•
save
•
whoami: display the user information
•
reboot
•
authorize
•
degrade
•
exportlog mode
•
ftp
•
help
•
ipconfig
•
kill
•
kill session id
•
logout: logs out from the current user
•
ping: to send the ping requests
•
tftp
•
telnet: connects to the remote system through telnet
•
terminal: to set the terminal size
•
xmodem
18.9.2 Configuration commands
The access commands are shown below.
•
allow: allows the IP address
•
deny: denies the IP address
•
modbus: enables or disables access to Modbus map
•
remove
•
removeall
•
snmp: enables or disables SNMP
•
ssl
•
sslv
• telnet
•
web
The alarm commands are shown below. Refer to Alarm Relays on page 18–1 for details on
using these commands.
•
add
•
alarm
•
del