GE Multilink ML3000 - Page 311

CHAPTER 18: MISCELLANEOUS COMMANDS MISCELLANEOUS COMMANDS
MULTILINK ML3000 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL 18–21
• period
The authorization commands are shown below.
•
auth
•
authserver
•
backend
•
clear-stats
•
portaccess
•
reauth
•
setport
•
show-port
•
show-stats
•
trigger-reauth
•
user auth
The device commands are shown below.
•
device
•
backpressure
•
broadcast-protect: enables or disables broadcast storm protection globally
•
flowcontrol
•
rate-time
• rate-threshold: sets the broadcast rate threshold (frames/sec)
•
setage: sets the mgtagetime
•
setport: sets the port configuration
The VLAN registration over GARP (GVRP) commands are shown below. Refer to Configuring
GVRP through the Command Line Interface on page 11–6 for details.
•
gvrp
•
help gvrp: configures GVRP parameters for dynamic VLAN
•
set-forbid: sets forbidden ports for a tag-based VLAN
•
show-ports: show ports current GVRP state
•
show-forbid: show forbidden ports for tag-based VLAN
•
set-ports: set GVRP port state usage
•
show-vlan: shows dynamic/static tag-based VLANs
•
static: convert dynamic VLAN to static VLAN
The IGMP commands are shown below. Refer to Commands on page 15–6 for additional
details.
•
group
• igmp
• mode
• mcast
• set-leave: enables or disables IGMP immediate leave status
•
set-port: sets the port mode
•
set-qi: sets the query interval (60 to 127) for router ports