GE Multilink ML3000 - Page 312

18–22 MULTILINK ML3000 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
MISCELLANEOUS COMMANDS CHAPTER 18: MISCELLANEOUS COMMANDS
• set-qri
•
set-querier: enables or disables switch as querier
•
show-group: displays IGMP group list
•
show-port: displays IGMP port mode
•
show-router: displays IGMP router list
The Link Aggregation Control Protocol (LACP) commands are shown below.
•
lacp
•
add port
•
del port
•
edit port
The port mirroring commands are shown below. Refer to Port Mirroring on page 9–1 for
additional details.
•
help port-mirror
•
prtmr: enables/disables port mirroring functionality
•
setport: defines the port mirroring ports
The port security commands are shown below. Refer to Securing Access on page 6–1 for
additional details.
•
action: sets the action type of secured port
•
allow: allows MAC addressing per port
•
help port-security
•
learn: enables/disables security for a single port or group of ports
•
ps: enables/disables security in system
•
remove: removes MAC addressing per port
•
signal: sets the signal type of the secured port
The quality of service (QoS) commands are shown below. Refer to Commands on page 14–
4 for additional details.
•
map
•
setpoint
• help qos
• setqos: configures QOS configuration usage
•
set-untag
•
set-weight: sets the port priority weights for all the ports in all the device
•
show-portweight: displays the current port weight priority
The remote monitoring (RMON) commands are shown below. Refer to Configuring RMON
on page 16–15 for additional details.
•
alarm: sets the owner for the alarm group
•
event: sets the owner for the event group
•
help rmon
•
history: sets the owner for the history group
•
statistics: sets the owner for the statistics group
The Rapid Spanning Tree Protocol (RSTP) commands are shown below. Refer to Configuring
RSTP through the Command Line Interface on page 13–4 for additional details.