GE Multilink ML3000 - Configuring Snmp with Enervista Secure Web Management Software; Example

16–10 MULTILINK ML3000 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
SNMP CHAPTER 16: SNMP
16.3 Configuring SNMP with EnerVista Secure Web
Management software
16.3.1 Example
Most SNMP v1 capabilities can be set using the EnerVista Secure Web Management
software. For SNMP v2 and v3 parameters, please refer to Configuring SNMP through the
Command Line Interface on page 16–4.
SNMP variables are used in conjunction with Alert definitions. Alert Definitions are covered
in the next chapter.
To configure SNMP,
 Select the Configuration > SNMP menu item.
 Use the Edit button to change the SNMP community parameters.
 Use the Add buttons to add the management and trap receivers.