GE Multilink ML3000 - Page 309

CHAPTER 18: MISCELLANEOUS COMMANDS MISCELLANEOUS COMMANDS
MULTILINK ML3000 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL 18–19
• show port-mirror: displays the port mirroring parameters
•
show port-security: displays the port security configuration parameters
•
show power: displays condition of power supplies, in redundant power supply
switches only
•
show qos: displays the QOS settings
•
show rmon: displays the rmon configuration parameters
•
show setup: displays the setup parameters of the system
•
show smtp: displays e-mail (SMTP) alert information
•
show snmp: displays information related to SNMP
•
show sntp: displays the configured SNTP servers details
•
show stats: displays the port statistics
•
show stp: displays Spanning Tree Bridge parameters
•
show subnet: displays the Subnet Mask of the system
•
show ssl
•
show sysconfig: displays system configurable parameters
•
show syscontact: displays the current system contact
•
show syslocation: displays the current system location
•
show sysname: displays the current system name
•
show time: displays the system time
•
show timeout: displays the system inactivity time out
•
show timezone: displays the configured time zone of the device
•
show uptime: displays up time of the system
•
show users: displays all configured users
•
show version: displays current version of the software
•
show vlan: displays the VLAN parameters of a specified type
•
show web
The set commands are listed below.
•
set bootmode
•
set date year
•
set daylight country
•
set prompt
•
set logsize
•
set password: sets the current user password
•
set snmp
•
set stp
•
set time
•
set timeformat
•
set timeout: sets the system inactivity time out
•
set timezone
•
set vlan: sets the VLAN type
The context-less commands are listed below.