GE Multilink ML3000 User Manual

CHAPTER 9: PORT MIRRORING & SETUP PORT MIRRORING & SETUP
MULTILINK ML3000 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL 9–7
Back pressure and flow control (continued)
ML3000(device)## backpressure rxthreshold=30
Rx Buffer Threshold set successfully
ML3000(device)## show backpressure
Rx Buffer Threshold : 30
ML3000(device)## show port
Keys: E = Enable D = Disable
H = Half Duplex F = Full Duplex
M = Multiple VLAN's NA = Not Applicable
LI = Listening LE = Learning
F=Forwarding B=Blocking
Port Name Control Dplx Media Link Speed Part Auto VlanID GVRP STP
-------------------------------------------------------------------------------
9 B1 E H 10Tx UP 10 No E 1 - -
10 B2 E H 10Tx DOWN 10 No E 1 - -
11 JohnDoe E H 10Tx DOWN 10 No E 1 - -
12 JaneDoe E H 10Tx DOWN 10 No E 1 - -
13 B5 E F 100Tx UP 100 No E 1 - -
14 B6 E H 10Tx DOWN 10 No E 1 - -
15 B7 E H 10Tx DOWN 10 No E 1 - -
16 B8 E H 10Tx DOWN 10 No E 1 - -
ML3000(device)## show port=11
Configuration details of port 11
--------------------------------------------------
Port Name : JohnDoe
Port Link State : DOWN
Port Type : TP Port
Port Admin State : Enable
Port VLAN ID : 1
Port Speed : 10Mbps
Port Duplex Mode : half-duplex
Port Auto-negotiation State : Enable
Port STP State : NO STP
Port GVRP State : No GVRP
Port Priority Type : None
Port Security : Enable
Port Flow Control : Disable
Port Back Pressure : Disable
Port Link Loss Alert : Enabled
ML3000(device)## setport port=11 flow=enable bp=enable
(continued on next page)

GE Multilink ML3000 Specifications

General

Brand	GE
Model	Multilink ML3000
Category	Network Router
Language	English