CHAPTER 9: PORT MIRRORING & SETUP PORT MIRRORING & SETUP
MULTILINK ML3000 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL 9–9
The braoadcast-protect command enables or disables the broadcast storm
protection capabilities.
broadcast-protect <enable|disable>
The rate-threshold command set the rate limit in frames per second.
rate-threshold port=<port|list|range> rate=<frames/sec>
The
show broadcast-protect command displays the broadcast storm protection
settings
show broadcast-protect
In Example 9-3, the broadcast protection is turned on. The threshold for port 11 is then set
to a lower value of 3500 broadcast frames/second.
To Next Page
Loading...
